Selector and Shift Lever Cable Bracket Replacement

Selector and Shift Lever Cable Bracket Replacement

Removal Procedure

1. Remove the battery tray. Refer to Battery Tray Replacement Service and Repair.





2. Disconnect the shift cable and selector cable ends (1) from the transmission shift lever and selector levers.

3. Pull the cable retainers (2) to release the shift lever and selector lever cable from the shift lever and selector lever cable bracket.

4. Disconnect the shift lever and selector lever cable (3) from the shift lever and selector lever cable bracket.





5. Remove the two shift lever and selector lever cable bracket fasteners (1).

6. Remove the shift lever and selector lever cable bracket (2) from the transmission.

Installation Procedure





1. Position the shift lever and selector lever cable bracket (2) on the transmission.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the two shift lever and selector lever cable bracket fasteners (1) and tighten to 22 Nm (16 lb ft).





3. Connect the shift lever and selector lever cable ends (1) to the transmission shift levers.

4. Install the shift lever and selector lever cable (3), to the shift lever and selector lever cable bracket.

5. Adjust the shift lever and selector lever cables. Refer to Manual Transmission Shift Lever Cable Adjustment Manual Transmission Shift Lever Cable Adjustment.

6. Install the battery tray. Refer to Battery Tray Replacement Service and Repair.

7. Verify correct operation of the transmission control assembly.