Manual Transmission Shift Lever and Selector Lever Cable Replacement

Manual Transmission Shift Lever and Selector Lever Cable Replacement

Removal Procedure

1. Remove the battery tray. Refer to Battery Tray Replacement Service and Repair.





2. Disconnect the shift lever and selector lever cable end (1) from the transmission shift lever and selector lever.

3. Pull the cable retainers (2) to release the shift lever and selector lever cable from the shift lever and selector lever cable bracket.

4. Disconnect the shift lever and selector lever cable from the shift lever and selector lever cable bracket.

5. Remove the floor console. Refer to Front Floor Console Replacement Front Floor Console Replacement.





6. Move the floor carpet in order to get access to the shift lever and selector lever cable grommet (1).

7. Remove the grommet fasteners (2).





8. Lift both cable adjustment retainers (1), one for each cable, to release the shift lever and selector lever cable.





9. Pull the shift lever and the selector lever cable retainers (1) from the transmission control assembly (3), then remove the shift lever and selector lever cable from the shift and selector control.

10. Pull the shift lever and the selector lever cable assembly through the cowl into the passenger compartment.

11. Remove the shift lever and the selector lever cable assembly from the vehicle.

Installation Procedure

1. Position the shift lever and the selector lever cable assembly in the vehicle.

2. Gently pull the shift lever and the selector lever cable assembly through the cowl into the engine compartment.





3. Connect the shift lever and the selector lever cable ends (1) to the transmission shift lever and the selector lever.

4. Install the shift lever and the selector lever cable to the shift lever and the selector lever cable bracket.





5. Move the floor carpet in order to get access to the shift lever and selector lever cable grommet (1).

Caution:
Refer to Fastener Caution Fastener Caution.

6. Install the grommet fasteners (2) and tighten to 9 Nm (80 lb in).





7. Connect the shift lever and selector lever cables to the shift and selector control adjusters (2).

8. Install the shift lever and selector lever cable retainers (1) to the transmission control (3).





9. Press down and lock both cable adjustment retainers (1), one for each cable, to adjust the shift lever and selector lever cable.

10. Adjust the shift lever and selector lever cables. Refer to Manual Transmission Shift Lever and Selector Lever Cable Adjustment Manual Transmission Shift Lever and Selector Lever Cable Adjustment.

11. Install the floor console. Refer to Front Floor Console Replacement Front Floor Console Replacement.

12. Install the battery tray. Refer to Battery Tray Replacement Service and Repair.

13. Verify correct operation of the transmission control assembly.