Transmission Mount Bracket Replacement - Rear

Transmission Mount Bracket Replacement - Rear

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement .

3. Using a suitable jack stand, support the rear of the powertrain.





4. Remove and DISCARD the transmission rear mount to bracket through bolt (1).





5. Remove and DISCARD the transmission rear mount bracket bolts (1).

6. Remove the transmission rear mount bracket (2).

Installation Procedure





1. Install the transmission rear mount bracket (2).

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the NEW transmission rear mount bracket bolts (1) and tighten to 100 Nm (74 lb ft) plus 30-45 degrees.





3. Install the NEW transmission rear mount to bracket through bolt (1) and tighten to 80 Nm (59 lb ft) plus 45-60 degrees.

4. Remove the jack stand.

5. Install the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement .

6. Lower the vehicle.