Transmission Rear Mount Replacement
Transmission Rear Mount Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove and DISCARD the transmission rear mount to bracket through bolt (1).
3. Remove the transmission rear mount bolt (2).
4. Push and hold the powertrain assembly forward and then remove the transmission rear mount (3).
Installation Procedure
1. Push and hold the powertrain assembly forward and then install the transmission rear mount (3).
Caution:
Refer to Fastener Caution Fastener Caution.
2. Install the transmission rear mount bolt (2) and tighten to 100 Nm (74 lb ft).
3. Install the NEW transmission rear mount to bracket through bolt (1) and tighten to 80 Nm (59 lb ft) plus 45-60 degrees.
4. Lower the vehicle.