B1015

DTC B1015

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B1015 00
- Vehicle Identification Number Information Malfunction

Circuit/System Description

When the ignition is turned ON, the advanced rear parking assist control module and the vehicle direction camera control module receives the vehicle identification number (VIN) from the body control module. The advanced control module will compare the VIN received to the VIN stored in memory.

Conditions for Running the DTC

Ignition voltage is between 9-16 V.

Conditions for Setting the DTC

The stored VIN does not match the received VIN.

Action Taken When the DTC Sets

* The parking assist system or the lane departure warning system is disabled.

* The driver information center displays SERVICE PARK ASSIST or SERVICE LANE DEPARTURE SYSTEM.

Conditions for Clearing the DTC

The stored VIN matches the VIN stored in the body control module.

Reference Information

Schematic Reference

Object Detection Schematics [1][2]Collision Avoidance and Parking Assist Systems

Connector End View Reference

Component Connector End Views Fuel Pump and Level Sensor Assembly

Description and Operation

Object Detection Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

1. Ignition ON.

2. Verify the DTC B1015 is not.

• If the DTC B1015 is set

1. Program the control module the DTC originally set in.

2. Verify the DTC does not set.

• If the DTC is sets, replace the control module the DTC set in.

• If the DTC does not set

3. All OK

• If the DTC B1015 is not set

3. All OK

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair

Control Module References Control Module References for the rear parking assist control module, vehicle direction camera control module replacement, programming and setup.