C0545

DTC C0545

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC C0545
- Steering Wheel Torque Sensor

For symptom byte information, refer to Symptom Byte List Symptom Byte List.

Circuit/System Description

The power steering control module continuously monitors the digital torque sensors torque and index current signals. As the steering wheel is turned and torsional twist is applied to the steering shaft, the steering input and output shafts are monitored via the torque signal circuit and then processed by the power steering control module to calculate the steering torque. The steering wheel torque sensor needs to be calibrated to be fully functional.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The power steering control module detects a short to ground, short to voltage, or an open/high resistance on any of the torque sensor circuits.

Action Taken When the DTC Sets

* DTC C0545 is stored in memory.

* The driver information center displays the SERVICE POWER STEERING warning message.

* No Steering assist.

Conditions for Clearing the DTC

* A current DTC will clear on the next malfunction free ignition cycle.

* A history DTC will clear after 40 consecutive malfunction free ignition cycles.

Reference Information

Schematic Reference

Power Steering Schematics Electrical Diagrams

Connector End View Reference

Component Connector End Views Fuel Pump and Level Sensor Assembly

Description and Operation

Power Steering System Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

1. Ignition ON.

2. Connect a scan tool and verify that DTC C0545 is not set.

• If the DTC C0545 is set
Refer to Circuit/System Testing.

• If the DTC C0545 is not set

3. All OK.

Circuit/System Testing

1. Ignition ON.

2. Perform the Power Steering Control Module Calibration Power Steering Control Module Calibration with a scan tool.

3. Verify the DTC does not set.

• If the DTC C0545 sets
Replace the Power Steering Gear.

• If the DTC does not reset

4. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair.

* Steering Gear Replacement (L99, LFX, LS3, N41) Steering Gear Replacement (N41)Steering Gear Replacement (LSA, NV9)

* Control Module References Control Module References for power steering control module replacement, programming and setup.