Power Steering

DTC C0569

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0569 3A
- System Configuration Calibration Not Programmed

Circuit/System Description

The power steering control module continuously monitors the parameters of the steering gear. If the power steering

control module is replaced, it needs to be calibrated to become fully operational.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

Electronic power steering control module calibration value does not meet the system requirement.

Action Taken When the DTC Sets

* DTC C0569 is stored in memory.

* No Steering assist.

Conditions for Clearing the DTC

A history DTC will clear after 40 consecutive malfunction free ignition cycles.

Reference Information

Schematic Reference

Power Steering Schematics Electrical Diagrams

Connector End View Reference

Component Connector End Views Fuel Pump and Level Sensor Assembly

Description and Operation

Power Steering System Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information.

Circuit/System Verification

1. Ignition ON.

2. Verify that DTC C0569 is not set.

• If the DTC C0569 is set

1. Program the K43 Power Steering Control Module.

2. Verify the DTC does not set.

• If the DTC sets, replace the Steering Gear.

• If the DTC does not set

3. All OK.

• If the DTC C0569 is not set

3. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair.

* Steering Gear Replacement (L99, LFX, LS3, N41) Steering Gear Replacement (N41)Steering Gear Replacement (LSA, NV9)

* Control Module References Control Module References for Power Steering Control Module replacement, programming and setup.