Folding Top Number 5 Bow Replacement
Folding Top Number 5 Bow Replacement
Removal Procedure
1. Remove the folding top quarter outer drain panel. Refer to Folding Top Quarter Outer Drain Panel Replacement Service and Repair.
2. Mark the location of the headliner in relation to the number 5 bow.
Note: Do Not remove the headliner from frame, just from the lower part of the number 5 bow.
3. Remove the headliner (1) from the number 5 bow track (2),
4. Remove the folding top cover from the number 5 bow as follows:
1. The folding top cover bead is held in place by a J type retainer.
2. Mark the location of all the straps and elastic strips when removing the folding top cover.
3. Mark on the number 5 bow with a grease pencil (1) where the folding top cover (2) and number 5 bow meet left side (Driver Side), this will assist in the reinstalling.
4. Pull the folding top cover bead (1) slowly out of the number 5 bow track, this will prevent damage to the retaining bead.
5. Remove the clips that attach the number 5 bow to the pivot bracket, left and right side.
6. Remove the number 5 bow (1) from the folding top frame.
Installation Procedure
1. Install the number 5 bow (1) to the folding top frame.
2. Install the headliner (1) to the number 5 bow track (2) until fully seated in the track.
3. Install the folding top cover to the number 5 bow as follows:
1. The top cover bead is held in place by a J type retainer.
2. Install all the straps and elastic strips the side linkage.
3. Start on the left side (Driver Side).
4. Align the mark on the number 5 bow and the folding top cover.
5. Work the folding top cover bead (1) until fully seated in the track of the number 5 bow (2).
4. Install the folding top frame assembly to the vehicle. Refer to Folding Top Quarter Outer Drain Panel Replacement Service and Repair.
5. Place the folding top in the lock position, check for appearance and fit.
6. Inspect the front edge of the folding top to windshield frame for a good seal.
7. Water test the vehicle to ensure a proper water tight seal.