Instrument Panel Electrical Center or Junction Block Replacement

Instrument Panel Electrical Center or Junction Block Replacement

Removal Procedure





1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LS7 or LS9) Battery Negative Cable Disconnection and ConnectionBattery Negative Cable Disconnection and Connection (LS3) Battery Negative Cable Disconnection and Connection.

2. Remove the carpet retainer. Refer to Carpet Retainer Replacement Carpet Retainer Replacement.

3. Fold the passenger side carpet back to expose the multi-use bracket.

4. Remove the retaining bolt which secures the multi-use bracket to the electrical wiring junction block.





5. Disengage the retaining clip from the outboard side, twist the electrical wiring block, and pull outward.

6. Remove the battery cable lead.

7. Disconnect three 64-way block connectors and 3 I/P wiring harness connectors.

8. Transfer all fuses and relays as required.

Installation Procedure





1. Position the electrical wiring junction block and connect 3 I/P wiring harness connectors and three 64-way block connectors.

2. Install the electrical wiring junction block to the multi-use bracket with the retaining bolt.

3. Install the battery cable lead.

4. Install the passenger side carpet to its original position.

5. Install the carpet retainer. Refer to Carpet Retainer Replacement Carpet Retainer Replacement.

6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LS7 or LS9) Battery Negative Cable Disconnection and ConnectionBattery Negative Cable Disconnection and Connection (LS3) Battery Negative Cable Disconnection and Connection.