Operation CHARM: Car repair manuals for everyone.

B1004




DTC B1004

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B1004

-
Keep Alive Memory (KAM) Reset

Circuit/System Description

The internal fault detection is handled inside the control module.

Conditions for Running the DTC

The control module microprocessor must be active/awake.

Conditions for Setting the DTC

The KAM in the control module has been reset. It is a normal occurrence when battery positive voltage or ground is removed from the module, such as a battery disconnect.

Action Taken When the DTC Sets

The microprocessor reverts back to the base programmed critical operating data until new data is learned and stored in KAM.

Conditions for Clearing the DTC

* A current DTC clears when the malfunction is no longer present.

* A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

Reference Information

Schematic Reference

Data Communication Schematics [1][2]Electrical Diagrams

Connector End View Reference

Component Connector End Views 5 Bow Lowered Switch (CM7)

Description and Operation

Data Link Communications Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool References

Control Module References Control Module References for Scan Tool Information

Circuit/System Verification

Verify that DTC B1004 is not set.

If the DTC is set, perform the setup procedure on the applicable control module, if the DTC resets replace the module.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for control module replacement, setup, and programming