Operation CHARM: Car repair manuals for everyone.

B1009




DTC B1009

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B1009

-
EEPROM Checksum Mismatch

Circuit/System Description

The electrically erasable programmable read-only memory (EEPROM) check sum error detection is handled inside the control module.

Conditions for Running the DTC

The control module runs the program to detect an EEPROM checksum error after each wake-up. The only requirements are battery positive voltage and ground.

Conditions for Setting the DTC

The control module retains an inverse copy of the digital value stored in certain blocks of memory in the EEPROM. The control module then reads the information from those certain blocks and adds the stored inverse value to the current value. If they do not equal 0, the module sets the DTC.

Action Taken When the DTC Sets

The control module reverts to base operation values programmed for those blocks of data that have failed the check sum test.

Conditions for Clearing the DTC

* A current DTC clears when the malfunction is no longer present.

* A history DTC clears when the control module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

Reference Information

Schematic Reference

Data Communication Schematics [1][2]Electrical Diagrams

Connector End View Reference

Component Connector End Views 5 Bow Lowered Switch (CM7)

Description and Operation

Data Link Communications Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool References

Control Module References Control Module References for scan tool information

Circuit/System Verification

Verify that DTC B1009 is not set.

If the DTC is set, perform the Restrain ID relearn on the control module. If the DTC resets, replace the applicable control module.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for control module replacement, setup, and programming