Crankshaft Balancer Installation

Crankshaft Balancer Installation

Special Tools

* EN-652 - Flywheel Holder

* EN-45059 - Angle Meter

For equivalent regional tools, refer to Special Tools Special Tools.




1. Install the EN-652 - holder (1), lock the flywheel (2) or the automatic transmission flex plate via the starter ring gear.





Note: Use care that the height (1) of the washer is facing towards the bolt.

2. Install the crankshaft balancer (2) and the washer (3).

Caution: Refer to Fastener Caution Fastener Caution.

Caution: Refer to Torque-to-Yield Fastener Caution Torque-to-Yield Fastener Caution.

3. Install a NEW crankshaft balancer bolt (4) and tighten the bolt in 3 passes using the EN-45059 - meter

1. First pass to 95 Nm (70 lb ft).

2. Second pass to an additional 45°,

3. Final pass to an additional 15°.