Cylinder Head Assemble

Cylinder Head Assemble

Special Tools

* EN-958 - Valve Stem Seal Installer

* EN-8062 - Valve Spring Compressor

* EN-8062-5 - Adapter

* EN-50717-2 - Compressor Assembly of EN-50717 - Kit

For equivalent regional tools, refer to Special Tools Special Tools.




1. Lubricate the valve stem and the valve guide with clean engine oil.

Note: Ensure all valve train components will be installed in their original position.

2. Install the valve (5).

3. Install the NEW valve stem oil seal (4), using the EN-958 - installer (2).

4. Loosely install the valve spring (3) and the valve spring retainer (1).




5. Install the EN-50717-2 - assembly (1) to the EN-8062 - compressor (4).

6. Install the EN-8062-5 - adapter (3) to the EN-8062 - compressor.

7. Install the compressor assembly to the cylinder head, so that the adapter (5) of the EN-50717-2 - assembly (1) contacts the valve spring retainer properly and the EN-8062-5 - adapter (3) contacts the valve disc (2). Prefix the EN-8062 - compressor (4).





Caution:
The valve stem keys must correctly seat in the valve spring cap. Engine damage may occur by not installing properly.

8. Apply pressure to the EN-50717-2 - assembly to push down the vale spring retainer (1) and compress the valve spring (3) until the valve keys (2) can be inserted. Carefully insert the valve keys then, so that they are proper installed to the valve stem grooves.

9. Carefully release the tension from the EN-50717-2 - assembly.

10. Inspect the valve keys and valve spring retainers for proper seat.

11. Remove the compressor assembly from the cylinder head.

12. Repeat the procedure with the remaining valves.