Drive Belt Installation

Drive Belt Installation

Special Tools

EN-6349 - Locking Pin

For equivalent regional tools, refer to Special Tools Special Tools.





1. Install the drive belt (1).





Note:
Make sure that the drive belt is aligned on the generator pulley (4), crankshaft balancer (5), drive belt tensioner (6) and water pump pulley (7). The drive belt must lie on the water pump pulley between the flange (1) and (2).

2. Check the position of the drive belt (3).





3. Release tension to the tensioner counterclockwise (1).

Note:
Allow tensioner to slide back slowly.

4. Remove EN-6349 - pin (2).

5. Apply tension to the tensioner at projection (1) clockwise.