Ignition Coil Installation

Ignition Coil Installation

Special Tools

EN-6009 - Remover/Installer Ignition Module

For equivalent regional tools, refer to Special Tools Special Tools.




1. Install the ignition coil module (2) with the EN-6009 - remover/installer (1).

2. Remove the EN-6009 - remover/installer (1).

Caution: Refer to Fastener Caution Fastener Caution

Note: Note the arrow on the cover.

3. Install the 2 ignition coil bolts and tighten to 8 Nm (71 lb in).

Note: Note the arrow on the cover.

4. Install the cover of the DIS ignition coil against the direction of the arrow.