Selector and Shift Lever Cable Bracket Replacement

Selector and Shift Lever Cable Bracket Replacement

Removal Procedure

1. Remove battery tray. Refer to Battery Tray Replacement Service and Repair.





2. Using a suitable pry tool, carefully remove shift lever and selector lever cable (2) from transmission control housing (3) using.

3. Remove shift lever and selector lever cable from shift lever and selector lever cable bracket (1).





4. Remove 2 shift lever and selector lever cable bracket bolts (1).

5. Remove shift lever and selector lever cable bracket (2).

Installation Procedure





1. Install shift lever and selector lever cable bracket (2).

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install 2 shift lever and selector lever cable bracket bolts (1) and tighten to 20 Nm (15 lb ft).





3. Install shift lever and selector lever cable (2) to shift lever and selector lever cable bracket (1).

4. Install shift lever and selector lever cable to transmission control housing (3).

5. Install battery tray. Refer to Battery Tray Replacement Service and Repair.