Operation CHARM: Car repair manuals for everyone.

Seat Heating and Cooling




DTC B1395

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC B1395 02

-
Device Voltage Reference Output Circuit Short to Ground

DTC B1395 05

-
Device Voltage Reference Output Circuit Short to Battery or Open

Description

This diagnostic applies to internal microprocessor integrity conditions within the heated seat module (HSM).

Conditions for Running the DTC

The HSM must be powered.

Conditions for Setting the DTC

The voltage sensing calibration data is out of range.

Action Taken When the DTC Sets

The heated seat function for both front seats will be disabled.

Conditions for Clearing the DTC

* The current DTC clears when the malfunction is no longer present and the power mode changes to OFF then back to RUN or ACC.

* The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.

Reference Information

Schematic Reference

Heated/Cooled Seat Schematics Electrical Diagrams

Connector End View Reference

Component Connector End Views A/C Compressor Clutch

Description and Operation

Heated Seats Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Testing

If either DTC is set history or current, replace the HSM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for HSM replacement, programming and setup