B1529

DTC B1529

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC B1529 03
- Device Voltage Reference Output Circuit Voltage Below Threshold

DTC B1529 07
- Device Voltage Reference Output Circuit Voltage Above Threshold

Diagnostic Fault Information






Circuit/System Description

The body control module (BCM) supplies voltage to the audio steering wheel control switches and monitors the return signal. Each switch state is associated to a set resistance value and when pressed a specific voltage drop occurs across the resistor unique to the switch. The BCM identifies the switch selection and activates the feature.

Conditions for Running the DTC

* Battery voltage is between 9-16 V

* The ignition is ON.

Conditions for Setting the DTC

B1529 03

* The BCM detects a short to ground in the B+ voltage reference circuit.

* The above condition is present for greater than 30 seconds.

B1529 07

* The BCM detects a short to voltage in the B+ voltage reference circuit.

* The above condition is present for greater than 30 seconds.

Action Taken When the DTC Sets

The BCM will ignore switch inputs.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear once 100 consecutive malfunction free ignition cycles have occurred.

Reference Information

Schematic Reference

Steering Wheel Secondary/Configurable Control Schematics Steering Wheel Secondary/Configurable Control Schematics

Connector End View Reference

Component Connector End Views A/C Compressor Clutch

Description and Operation

Steering Wheel Controls Description and Operation Steering Wheel Controls

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

Ignition ON, observe the scan tool BCM SWC Bank 1 Status parameter. The reading should be idle and change between SW1-SW7 when pushing the appropriate switch.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the right steering wheel control switch.

2. Ignition ON, test for B+ between the voltage reference circuit terminal 3 and ground.

• If less than the specified value, test the voltage reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.

• If greater than the specified value, test the voltage reference circuit for a short to voltage. If the circuit tests normal, replace the BCM.

3. If all circuits test normal, test or replace the right steering wheel control switch.

Component Testing

1. Ignition OFF, disconnect the harness connector at the right steering wheel control switch.

2. Test the resistance between the voltage reference terminal 3 and the signal terminal 4 while depressing the appropriate steering wheel controls switch listed below.

• If not the specified range, replace the steering wheel switch.





Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair.

Control Module References Control Module References for BCM replacement, programming and setup