C0201

DTC C0201

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0201 00

-
Antilock Brake System (ABS) Enable Relay Contact Circuit

Circuit/System Description

The solenoid relay, located within the electronic brake control module (EBCM), supplies battery voltage to all of the valve solenoids.

Conditions for Running the DTC

* Ignition ON.

* The solenoid relay is commanded ON.

Conditions for Setting the DTC

One or more of the following conditions exists:

* The EBCM detects no change in voltage when the relay is commanded.

* The EBCM detects a stuck closed solenoid valve relay.

Action Taken When the DTC Sets

The EBCM sends a serial data message to illuminate the warning indicator/message.

Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present.

* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information

Schematic Reference

Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems

Connector End View Reference

Component Connector End Views A/C Compressor Clutch

Description and Operation

ABS Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

1. Ignition ON, verify that DTC C0201 is not set.

• If DTC is set, replace the EBCM and verify the DTC does not reset.

2. If the DTC resets, replace the brake pressure modulator valve.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Brake Pressure Modulator Valve Replacement Brake Pressure Modulator Valve Replacement

* Control Module References Control Module References for EBCM replacement, programming and setup