C0245

DTC C0245

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0245 00

-
Wheel Speed Sensor Frequency

Circuit/System Description

The wheel speed sensor receives ignition voltage from the electronic brake control module (EBCM) and provides an output signal back to the EBCM. As the wheel spins the sensor sends a DC square wave signal to the EBCM. The EBCM uses the frequency of this signal to calculate the wheel speed.

Conditions for Running the DTC

* Ignition voltage is greater than 10 V.

* No wheel speed sensor faults exist.

* Brake is not applied.

* Vehicle is not cornering.

Conditions for Setting the DTC

Wheel speed differences between one wheel and the others is greater than 25 percent.

Action Taken When the DTC Sets

* The EBCM disables the traction control system (TCS) and vehicle stability enhancement system (VSES) for the duration of the ignition cycle.

* A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.

* The history DTC will clear after 40 consecutive fault-free drive cycles have occurred.

Note:
During normal diagnostic and/or repair verification technicians may find that the ABS, Traction Control and/or Stabilitrak indicators may be ON with NO DTCs displayed by the EBCM. Do not replace the EBCM for this condition.

If the ABS, Traction Control and/or Stabilitrak telltales are ON with no DTCs set, perform the following steps:

1. Remove the key from the ignition, open and close the driver's door to turn off retained accessory power (RAP), and wait 60 seconds.

2. Ignition ON, if the ABS, Traction Control and/or Stabilitrak telltales are still illuminated, operate the vehicle at speeds greater than 15 km/h (10 mph) to complete the self test. The EBCM should request all telltale indicators to turn OFF.

3. If the telltales remain ON with no DTCs set after the drive cycle, disconnect the battery for at least 60 seconds then reconnect the battery.

4. Operate the vehicle at speeds greater than 40 km/h (25 mph), the EBCM should request all telltale indicators to turn OFF.

Diagnostic Aids

* Faulty wheel speed sensor will not set this DTC.

* A vehicle using a space saver spare will not set this code.

Reference Information

Schematic Reference

Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems

Connector End View Reference

Component Connector End Views A/C Compressor Clutch

Description and Operation

ABS Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

Ignition ON, observe the scan tool Wheel Speed Sensor parameters while spinning the wheels. The readings should be analog to the wheel speeds.

Circuit/System Testing

1. Verify that all tires have the proper air pressure.

• If not the proper air pressure, adjust the air pressure for all tires to specification and verify the DTC does not reset. If the DTC resets, replace the EBCM.

2. Verify that all wheels and tires are the proper size.

• If incorrect wheel or tire size, replace the incorrect wheel or tire and verify the DTC does not reset. If the DTC resets, replace the EBCM.

3. If all components test normal, replace the EBCM.