Fuel Injector Solenoid Coil Test

Fuel Injector Solenoid Coil Test

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

The engine control module (ECM) supplies a separate high voltage supply circuit and a high voltage control circuit for each fuel injector. The injector high voltage supply circuit and the high voltage control circuit are both controlled by the ECM. The ECM energizes each fuel injector by grounding the control circuit. The ECM controls each fuel injector with 65 V. This is controlled by a boost capacitor in the ECM. During the 65 V boost phase, the capacitor is discharged through an injector, allowing for initial injector opening. The injector is then held open with 12 V. A fuel injector coil winding resistance that is too high or too low will affect the engine driveability. The fuel injector coil windings are affected by temperature. The resistance of the fuel injector coil windings will increase as the temperature of the fuel injector increases.

Reference Information

Schematic Reference

Engine Controls Schematics [1][2]Electrical Diagrams

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Component Testing

Note:

* The resistance test must be performed at the fuel injector or mis-diagnosis will occur.

* The DMM and test leads must be calibrated to 0 ohms in order to prevent mis-diagnosis.

1. Test for 1.9-2.3 ohms at 20°C (68°F) between the high voltage supply circuit terminal 2 and the high voltage control circuit terminal 1 at the Q17 fuel injector.

• If not within the specified range, replace the Q17 fuel injector.

2. Measure the resistance between each terminal at the Q17 fuel injector and the Q17 fuel injector housing/case. The DMM should display OL ohms.

• If less than the specified value, replace the Q17 fuel injector.

3. If the injectors measure OK, perform the Fuel Injector Balance Test. Refer to Fuel Injector Balance Test Fuel Injector Balance Test.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Fuel Injection Fuel Rail Assembly Replacement - Bank 1 Fuel Injection Fuel Rail Assembly Replacement - Bank 1

* Fuel Injection Fuel Rail Assembly Replacement - Bank 2 Fuel Injection Fuel Rail Assembly Replacement - Bank 2