Battery Current Sensor: Service and Repair

Battery Current Sensor Replacement

Removal Procedure




1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.

2. Disconnect the battery current sensor from the body harness connector.

3. Unclip the battery current sensor from the battery tray.

4. Remove the battery tray. Refer to Battery Tray Replacement Service and Repair.

5. Remove the battery negative cable frame ground nut (4) and terminal (5).





Note: Observe the position of the battery current sensor when removing.

6. Slide the battery current sensor (2) off the battery negative cable (1).

Installation Procedure




1. Install the battery current sensor (2) onto the battery negative cable (1).





Caution: Refer to Fastener Caution Fastener Caution.

2. Install the battery negative cable frame ground terminal (5) and bolt (4). Tighten to 22 Nm (16 lb ft).

3. Install the battery tray. Refer to Battery Tray Replacement Service and Repair.

4. Clip the battery current sensor onto the battery tray.

5. Connect the battery current sensor to the body harness connector.

6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.