Operation CHARM: Car repair manuals for everyone.

Power Outlet Receptacle Inoperative (120 VAC)




Power Outlet Receptacle Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Diagnostic Fault Information






Circuit/System Description

The accessory power receptacle and cigarette lighter receptacle are supplied B+ all the time.

Reference Information

Schematic Reference

Connector End View Reference

Component Connector End Views Connector Views

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Special Tools

BO 48871 - Cigar Lighter Socket Remover

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the appropriate X80 Accessory Power Receptacle or E32 Cigarette Lighter Receptacle.

2. Test for less than 5 ohms between the ground circuit terminal C and ground.

If greater than the specified range, test the ground circuit for an open/high resistance.

3. Verify that a test lamp illuminates between the B+ circuit terminal A and ground.

If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.

4. Replace the X80 Accessory Power Receptacle or E32 Cigarette Lighter Receptacle.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.