Clutch and Differential Housing Disassemble

Clutch and Differential Housing Disassemble

Special Tools

* M-680770 - Universal Sliding Mallet

* R-0007758 - Holding Fixture

* R-0407008 - Counter Shaft Bearing Remover

* R-0407010 - Input Shaft Needle Bearing Puller and Driver

* R-0407013 - Gearshift Device Bushing Puller

* R-0007761 - Universal Handle for Pullers and Installers

* T-0207928 - Retainer Remover

For equivalent regional tools, refer to Special Tools F13-5/F15-5/F17-5 (M26) - Manual Transmission.





1. Remove the vehicle speed sensor bolt (1) and vehicle speed sensor assembly (2).

2. Remove and discard the vehicle speed sensor O-ring seal (3).





3. Remove the transmission magnet (1).





4. Using the T-0207928 - retainer remover (3) with the M-680770 - sliding mallet (2) remove the front wheel drive shaft oil seal assembly (1).





5. Remove the clutch yoke shaft bushings (1).





6. Remove the clutch release bearing collar bolt (1).

7. Remove the clutch release bearing collar (2).

8. Remove the clutch release bearing collar O-ring seal (3).





9. Remove the input shaft front bearing assembly (3) using the R-0407010 - driver (2) and the R-0007761 - handle (1).





10. Remove the main shaft front bearing assembly (1) using the R-0407008 - remover.





11. Remove the shift shaft bushings (3) using the R-0407013 - puller (2) and the M-680770 - mallet (1).





12. Remove the clutch and differential housing (1) from the R-0007758 - holding fixture.