Transmission Rear Mount Bracket Replacement

Transmission Rear Mount Bracket Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement .

3. Using a suitable jack stand, support the rear of the powertrain.





4. Remove and DISCARD the transmission mount to bracket through bolt (1).





5. Remove and DISCARD the transmission mount bracket bolts (1).

6. Remove the transmission rear mount bracket (2).

Installation Procedure





1. Install the transmission rear mount bracket (2).

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the NEW transmission mount bracket bolts (1) and tighten to 100 Nm (74 lb ft) plus 30-45 degrees.





3. Install the NEW transmission mount to bracket through bolt (1) and tighten nut to 80 Nm (59 lb ft) plus 45-60 degrees.

4. Remove the jack stand.

5. Install the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement .

6. Lower the vehicle.