Cross-Member: Service and Repair

Drivetrain and Front Suspension Frame Front Support Replacement


Removal Procedure

Warning:Refer to Approved Equipment for Collision Repair Warning

Warning:Refer to Collision Sectioning Warning

Warning:Refer to Glass and Sheet Metal Handling Warning

1.Disable the SIR System. Refer to SIR Disabling and Enabling

2.Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection

3.Remove all related panels and components.

4.Visually inspect the damage. Repair as much of the damage as possible.

5.Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair





6.Create cut lines on the drivetrain and front suspension frame front support.





Note:Do not damage any inner panels or reinforcements.

7.Cut the panel where sectioning is to be performed.





8.Locate and mark all the necessary factory welds of the drivetrain and front suspension frame front support.

9.Drill all factory welds. Note the number and location of welds for installation of the service assembly.





10.Remove the damaged drivetrain and front suspension frame front support.

Installation Procedure





1.Cut the drivetrain and front suspension frame front support in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint.

2.Create a 50 mm (2 in) backing plate from the unused portion of the service part.

3.Drill 8 mm (5/16 in) along the sectioning cut on the remaining original part. Locate these holes 13 mm (1/2 in) from the edge of part and spaced 40 mm (11/2 in) apart.

4.Prepare all mating surfaces as necessary.

5.Fit the backing plates halfway into the sectioning joints, clamp in place and plug weld to the vehicle.

6.Align the drivetrain and front suspension frame front support.





7.Drill 8 mm (5/16 in) for plug welding along the edges of the front suspension frame front support as noted from the original panel.

8.Clean and prepare the attaching surfaces for welding.

9.Position the front suspension frame front support on the vehicle.

10.Verify the fit of the front suspension frame front support.

11.Clamp the front suspension frame front support into position.





12.Plug weld accordingly.

13.To create a solid weld with minimum heat distortion, make 25 mm (1 in) stitch welds along the seam with 25 mm (1 in) gaps between them. Then go back and complete the stitch weld.

14.Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair .

15.Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems .

16.Install all related panels and components.

17.Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

18.Enable the SIR system. Refer to SIR Disabling and Enabling .