With Mechanical Clutch

Description:

1. Disconnect return spring at clutch fork.

2. Position clutch lever firmly against rubber bumper on brake pedal bracket.

3. Push outer end of fork rearward until release bearing lightly contacts pressure plate.

4. Loosen locknut and adjust rod length so that swivel slips freely into gauge hole. Increase length until all lash is removed from linkage.

5. Reinstall rod into lower hole on lever. Install two washers and cotter pin. Tighten locknut without changing rod length.

6. Reinstall return spring and check pedal travel. Pedal travel should be 1 3/8 to 1 5/8 inch.