Ignition Lock Cylinder

Fig. 1 Lock Cylinder Installation:

1. Disconnect battery ground cable.
2. Place lock cylinder in the Run position.
3. Remove steering wheel.
4. Remove turn signal switch. It is not necessary to completely remove the turn signal switch from the column. Pull switch rearward enough to slip it over the end of the shaft. Do not pull the harness out of the column.
5. Remove attaching screw and lock cylinder set. Do not drop the screw into the column.
6. To install, align cylinder key with keyway in housing, as shown in Fig. 1. Push the lock completely inward, install attaching screw and torque to 40 lb in, on standard columns, or 22 lb in, on tilt columns.