ABS - Reading Trouble Codes
91chevy07
Number: 91-228-5
Section: 5
Date: March 1991
Corporate Bulletin No.: 165003
Subject: ANTI-LOCK BRAKES - READING TROUBLE CODES
Model and Year: 1988-91 C/K,R/V, S/T TRUCKS M/L, G VANS WITH ANTI-LOCK BRAKES
Trucks equipped with either Rear Wheel Anti-lock (RWAL) or 4 Wheel Anti-Lock (4WAL) will store a trouble code when a fault is detected with the system. On vehicles with RWAL the red BRAKE light will be illuminated when a fault is detected. On vehicles with 4WAL the amber Anti-Lock light will be illuminated. There are two methods that can be used to read the stored trouble codes, manual flashout and Tech 1.
The manual flashout method is NOT recommended. This method, (which is covered in the applicable service manual) does not give the detailed diagnostic information that the Tech 1 tool is capable of, such as reset switch status and real time wheel speed display. Additionally, when using manual flashout to read newly introduced RWAL soft codes technicians may cause the codes to be cleared and a false code 9 to set (reference Dealer Service Bulletin No. 91-101-5). Erratic grounding of the ALDL terminals can also cause false codes to be set.
Chevrolet, therefore, recommends the use of the TECH 1 tool over manual flashout in all diagnostic procedures involving both RWAL and 4WAL.
IMPORTANT: When using the Tech 1 remember to use a scan tool with a serial number above xx002000 along with tool number TK2650 (4WAL cartridge, special RWAL 4WAL adapter, and harness).