Campaign Procedures, Parts & Warranty Information
SERVICE PROCEDURE1. Remove old dipstick.
2. Install new lock-seal dipstick.
PARTS INFORMATION
A new lock-seal fluid level indicator (dipstick), installation instructions and instructions for checking the transmission fluid level will be mailed to owners of record by GMC Truck on a no charge basis.
If additional transmission fluid level indicators arc required, they should be obtained from General Motors Service Parts Operation (GMSPO). To ensure that these parts are obtained as soon as possible, they should be ordered from GMSPO on a C.I.O. order with no special instruction code but order under an advise code (2).
WARRANTY INFORMATION
Dealers should submit a warranty claim on each vehicle completed under this campaign.
CAMPAIGN IDENTIFICATION LABEL
No Campaign Identification Label is required for this campaign.
ADMINISTRATIVE PROCEDURE
Procedures covering this campaign are outlined in Section V of your dealerships "GMC Truck Warranty Claims Processing Manual" # P9119.
INSTALLATION OF TRANSMISSION FLUID DIPSTICK
1. OPEN VEHICLE HOOD
2. Locate transmission fluid level dipstick near left rear of engine (indicated by arrow in Figure 1). Dipstick handle is formed into a small loop of wire.
3. Remove old dipstick from vehicle. Place in shipping tube and dispose properly. Keep dipstick out of the reach of children
4. With the new dipstick handle in the unlocked position push the dipstick all the way into the transmission fill tube (Figure 2).
5. Flip the handle down to lock the dipstick in place (Figure 3)