Valve Body Replace

1. Raise and support vehicle.

2. Drain transmission fluid through rear extension.

3. Remove oil pan attaching bolts, then the oil pan and gasket.

4. Remove oil strainer attaching bolts, then the strainer and gasket.

5. Remove manual detent roller and spring assembly.

6. Disconnect electrical connections at governor pressure switch.

7. Remove solenoid from transfer plate reinforcement.

8. Remove solenoid from solenoid.

9. Remove solenoid pipes from valve body and case.

10. Remove governor pressure switch.

11. Remove transfer plate reinforcement attaching bolts, then the reinforcement.

12. Remove servo cover attaching bolts, then the cover and gasket.

13. Remove valve body attaching bolts, then the valve body and manual link valve, being careful not to lose check balls.