Initial Inspection

INITIAL INSPECTION

^ Check for bare, broken, or disconnected wires.
^ Check for pinched, damaged, or disconnected vacuum hoses.
^ Make sure servo and throttle linkages operate freely and smoothly.
^ Check "IGN/GAUGES" 20 amp fuse.
^ Verify check valve functions correctly.

If preliminary inspection reveals no solution, follow the six diagnostic charts, to isolate and fix the problem. Continuity and Resistance Chart has also been provided as supplementary information on what the controller, servo, and control switch voltages and resistances are when the system is operating correctly. These charts are helpful in isolating electrical problems.

A quick-check box is made available through Kent-Moore Tool Company under tool number J 34185 (or equivalent). This quick-check box will plug in place of the controller and determine which part of the system has a problem. Instructions on the operation of this tool are provided with the tool.