Charging Procedure

CAUTION: Refer to "Service Precautions".

When charging the battery in the vehicle, proceed to Step 1. If charging side terminal batteries out of the vehicle, install an adapter kit GM P/N 12303040 or equivalent. The adapters should be tightened against the lead terminals of the battery to keep resistance between the adapter and the battery terminals to a minimum.
1. Make sure all charger connections are clean and tight.
2. Charge the battery using the charger setting for 12-volt batteries that gives the highest charge rate to the battery until the green dot appears. (Do not use charger settings for jump-starting vehicles to charge the battery, refer to the charger manufacturer's instructions). The battery should be checked periodically while charging. Tap the hydrometer lightly on the top to dislodge any air bubbles that may prevent a correct indication.
3. If the battery feels hot, temperature above 52°C (125°F), or if violent gassing or spewing of electrolyte through the vent holes occurs, discontinue charging or reduce the charging rate.
4. After charging, the battery should be tested as outlined in "Diagnosis of the Battery".