Ignition & Key Alarm Switch

^ Tools Required:
- J 41352 Modular Column Holding Fixture
- Or Equivalent

Remove or Disconnect
1. Do steps 1 through 7, Remove or Disconnect LOWER SHROUD, UPPER SHROUD, in this section.
2. Do steps 2 through 6, "Remove or Disconnect", T /S & MULTIFUNCTION SWITCH ASSEMBLY.





3. Alarm switch from lock module assembly (15).
- Gently pry retaining clip on alarm switch with small blade screwdriver.
- Rotate alarm switch 1/4 turn and remove.





4. Two tapping screws (18).
5. Ignition & key alarm switch assembly (19).
- Wire harness from slot in steering column housing assembly (26).

Install or Connect

NOTICE: Refer to NOTICE about fasteners on page 3F5-1 in this section. Failure to do may result in component damage or malfunction of steering column.

1. Ignition & key alarm switch assembly (19).
- Route wire harness through slot in steering column housing assembly (26). Secure wire harness with a wire harness strap (22) through hole located in the bottom of housing assembly (26).
2. Two tapping screws (18).
- Tighten screws (18) to 1.4 Nm (12 lb in).
3. Alarm switch to lock module assembly (15).
a. Switch with retaining clip parallel to lock cylinder (17).
b. Rotate switch 1/4 turn until locked into place.
4. Do steps 3 through 8, "Install or Connect", T/S & MULTIFUNCTION SWITCH ASSEMBLY.