P0222

Diagnostic Chart:

Wiring Chart:

CIRCUIT DESCRIPTION

The Accelerator Pedal Position (APP) module provides a voltage signal that changes relative to the accelerator pedal position. There are three sensors which are located within the APP module that are scaled differently.

CONDITIONS FOR SETTING THE DTC

^ The voltage is less than 0.25 volt on the APP 2 sensor.

^ The condition met for 2 seconds.

ACTION TAKEN WHEN THE DTC SETS

^ The Service Throttle Soon lamp will not illuminate when one APP DTC sets. The PCM will only illuminate the Service Throttle Soon lamp when multiple APP DTCs set.

^ The PCM records the operating conditions at the time the diagnostic fails. This information stores in the Failure Records.

CONDITIONS FOR CLEARING THE MIL/DTC

^ A History DTC will clear after forty consecutive warm-up cycles during which the diagnostic does not fail (the coolant temperature has risen 5°C (40°F) from the start up coolant temperature and the engine coolant temperature exceeds 71°C (160°F) of that same ignition cycle).

^ Use of a Scan tool will clear the DTC codes.

DIAGNOSTIC AIDS

There are no driveability issues associated with the APP module unless a DTC is present. The most likely cause of this DTC are poor connections or the sensor itself. The least likely is a PCM problem.

A scan tool reads the APP 2 position in volts and should read about 4.5 volts with the throttle closed and the ignition ON or at idle. The voltage should decrease at a steady rate as the throttle is moved toward WOT. Also, 90% pedal travel is acceptable for a correct APP operation. Scan the APP 2 sensor while depressing the accelerator pedal with the engine stopped and the ignition ON. The display should vary from about 4.5 volts when the throttle was closed to about 1.5 volts when the throttle is held at the Wide Open Throttle (WOT) position.

TEST DESCRIPTION

The number(s) below refer to the step number(s) on the Diagnostic Table.

2. This step determines if P0222 is the result of a hard failure or an intermittent condition.

3. This step checks the PCM and wiring.