Crankshaft Balancer Installation

1. Tap the crankshaft balancer into place with a mallet.

IMPORTANT: Before installing the crankshaft balancer, check the oil seal contact area for grooving and roughness. Replace the crankshaft balancer if necessary.

2. Make sure that the key is in place.
3. Make sure that the crankshaft balancer is completely installed on the crankshaft.
4. Install the bolt and the washer.
^ Tighten the bolt to 270 Nm (200 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.





5. Install the crankshaft pulley and bolts.
^ Tighten the crankshaft pulley bolts to 50 Nm (37 ft. lbs.).