Left Side

REMOVAL PROCEDURE
1. Disconnect the negative battery cables.
2. Raise the vehicle.
3. Remove the left front tire.
4. Remove the splash shield from the left front wheel well.
5. Remove the lead wires from the glow plugs (1) in cylinders 1 and 3.
6. Remove the glow plugs (1) from cylinders 1 and 3. If the glow plug was damaged during removal, refer to Damaged Glow Plug Removal
7. Remove the Engine Cover.
8. From the inside of the vehicle, remove the lead wires from the glow plugs (1) in cylinders 5 and 7.
9. Remove the glow plugs(1) from cylinders 5 and 7. If the glow plug was damaged during the REMOVAL PROCEDURE, refer to Damaged Glow Plug Removal. Damaged Glow Plug Removal

INSTALLATION PROCEDURE
1. Install the glow plugs (1) into cylinders 1 and 3 by reaching through the left front wheel well.

^ Tighten the glow plugs to 17 Nm (13 lb. ft.).

2. Install the lead wires for cylinder 1 and 3.
3. Install the splash shield in the left front wheel well.
4. Inspect the wire routing, ensuring that the lead wires are not rubbing against the exhaust manifold or any part that may harm the wire insulation.
5. Install the left front tire.
6. Install the glow plugs (1) into cylinders 5 and 7 from inside of the vehicle.

^ Tighten the glow plugs to 17 Nm (13 lb. ft.).

7. Connect the lead wires to the glow plugs.
8. Connect the negative battery cables.

IMPORTANT: Ensure that the PCM electrical harness is properly routed to avoid contact with the Engine Cover during installation.

9. Install the Engine Cover.