Right Side

REMOVAL PROCEDURE
1. Raise the vehicle.
2. Remove the right front tire.
3. Remove the splash shield from the right front wheel well.
4. Remove the lead wires from the glow plug in cylinder 2.
5. Remove the lead wires for the glow plugs in cylinders 4 and 6 at the harness connectors.
6. Remove the heat shroud for the glow plug in cylinder 4.
7. Remove the heat shroud for cylinder 6. Slide the shrouds back far enough in order to allow access for unplugging the wires at cylinder 4 and 6 glow plugs.
8. Remove the glow plugs from cylinders 2, 4, and 6. If the glow plug was damaged during the REMOVAL PROCEDURE, refer to Damaged Glow Plug Removal. Damaged Glow Plug Removal
9. Disconnect the lead wire at the glow plug from cylinder 8 from inside of the vehicle.
10. Remove the glow plug from cylinder 8. If the glow plug was damaged during the REMOVAL PROCEDURE, refer to Damaged Glow Plug Removal. Damaged Glow Plug Removal


INSTALLATION PROCEDURE
1. Install the glow plug into cylinder 8 from inside of the vehicle.

^ Tighten the glow plugs to 17 Nm (13 lb. ft.).

2. Connect the lead wire to the cylinder 8 glow plug.
3. Install the glow plugs into cylinders 2, 4, and 6 by reaching through the right front wheel well.

^ Tighten the glow plugs to 17 Nm (13 lb. ft.).

4. Install the lead wire to glow plug 6.
^ Slide the shroud over the wire lead.
^ Fasten the shroud to the studs.
^ Repeat step 4 for the cylinder 4 glow plug.
^ Tighten the heat shroud nuts to 23 Nm (17 lb. ft.).

5. Connect the wires for the glow plugs in cylinders 4 and 6 to the connectors at the wire harness.
6. Install the lead wire for the cylinder 2 glow plug.
7. Install the splash shield in the right front wheel well.
8. Inspect the wire routing, ensuring that the lead wires are not rubbing against the exhaust manifold or any part that may harm the wire insulation.
9. Install the right front tire.