4L60-E Automatic Transmission

REMOVAL PROCEDURE
1. Raise the vehicle.





2. Remove the electrical connector from the speed sensor.
3. Remove the bolt.
4. Remove the speed sensor and the O-ring seal.
5. Inspect the seal and the transmission case. Replace the seal, if necessary.

INSTALLATION PROCEDURE





1. Install the speed sensor and the O-ring seal into the transmission.

2. Install the bolt.
^ Tighten the bolt to 11 Nm (97 inch lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

3. Install the electrical connector to the speed sensor.
4. Lower the vehicle.