Steering Column Housing Assembly

Standard Steering Column - Part 1 Of 2:

Standard Steering Column - Legend - Part 2 Of 2:

^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- J 41396 Park Lock Cable Pliers

REMOVE OR DISCONNECT
1. Do all steps under REMOVE OR DISCONNECT, in COIL ASSEMBLY.
2. Do steps 6 and 7 under REMOVE OR DISCONNECT, in T/S & MULTIFUNCTION SWITCH ASM.
3. Do steps 2 through 6 under REMOVE OR DISCONNECT, in LINEAR SHIFT ASM (REMOVAL).
4. Do steps 2 through 6 under REMOVE OR DISCONNECT, in UPPER COLUMN HOUSING COMPONENTS.
5. Do steps 3 through 9 under REMOVE OR DISCONNECT, in LOCK MODULE ASM.
6. Four torx head screws (9).
7. Steering column housing assembly (26).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Steering column housing assembly (26).
2. Four torx head screws (9).

Tighten
Tighten screws (9) to 9 Nm (80 lb in).

3. Do steps 1 through 7 under INSTALL OR CONNECT, in LOCK MODULE ASM.
4. Do steps 1 through 5 under INSTALL OR CONNECT, in UPPER COLUMN HOUSING COMPONENTS.
5. Do steps 1 through 6 under INSTALL OR CONNECT, in LINEAR SHIFT ASM (REMOVAL), and Adjust and Inspect.
6. Do steps 1 and 2 under INSTALL OR CONNECT, in T/S & MULTIFUNCTION SWITCH ASM.
7. Do all steps under INSTALL OR CONNECT, in COIL ASSEMBLY.