Transfer Case Control Module Replacement (Automatic 4WD)

REMOVAL PROCEDURE





1. Remove the lower instrument panel trim.
2. Remove the two screws securing the auto transfer case control module to the bracket.
The bracket is mounted on the I/P reinforcement.
3. Remove the electrical connector from the auto transfer case control module.

INSTALLATION PROCEDURE





1. Install the electrical connector to the auto transfer case control module.
2. Install the two screws securing the auto transfer case control module to the bracket.
- Tighten the transfer case control module screws to 8 Nm (71 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

3. Install the lower instrument panel trim.