Brake Light Switch: Adjustments

1. Insert the stoplamp switch threads (2) into the mounting bracket (4) and turn the switch clockwise. Secure with a locknut. Do not tighten fully.
2. Pull the brake pedal toward the stoplamp switch.
3. Adjust the clearance between the end of the stoplamp switch threads and the brake pedal return cushion by turning the stoplamp switch either clockwise or counterclockwise until the clearance is within 1.5 - 2.0 mm (0.0 - 0.08 inch).

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

^ Tighten the stoplamp switch locknut to 10 Nm (89 inch lbs.).