Control Valve Body Assembly Installation

^ Tools Required
- J 3387-2 Guide Pins





1. Install the check ball (193) into the case fluid passages.





2. Install J 3387-2 into the transmission case.
3. Install the spacer plate to transmission case gasket (132).
4. Install the spacer plate (130).
5. Install the control valve body to spacer plate gasket (129).
6. Install the servo cover gasket (168).
7. Install the servo cover (169).
8. Install the servo cover bolts (152).
^ Tighten the bolts to 24 Nm (18 ft. lbs.).





9. Install the manual valve link (139) into the manual valve (138). The long side of the manual valve link (139) fits into the manual valve (138).
10. Install the control valve body assembly (128) onto the transmission case (101). Connect the manual valve link (139) to the detent lever (140).
11. Remove J 3387-2.





12. Install the manual detent roller assembly (145).
13. Install the control valve body bolts (155).
^ Tighten the bolt to 19 Nm (14 ft. lbs.).





14. Install the reinforcement plate (146).
15. Install the reinforcement plate bolts (152).
16. Install the governor oil pressure,switch (137).
^ Tighten the pressure switch to 10 Nm (89 inch lbs.).

17. Install the oil pressure switch (176), if equipped.





18. Install new seals (151) onto the TCC solenoid pipes (149) and (150).

IMPORTANT: Make sure the TCC Solenoid pipes do not interfere with the manual valve operation.

19. Install the solenoid pipes (149) and (150) into the TCC solenoid (147).
20. Install the pipes (149) and (150) into the control valve assembly (500) and the transmission oil pump.
21. Install the TCC solenoid bolts (152).
^ Tighten the bolts to 19 Nm (14 ft. lbs.).





22. Install the wiring harness (148).
23. Connect the wiring harness to the electrical components.