Operation CHARM: Car repair manuals for everyone.

Gearshift Control Lever Installation

INSTALLATION PROCEDURE





1. Install the gearshift control lever into the gearshift lever case and push down on the shift control lever pivot (4) and turn clockwise 90° (1/4 turn) and release.
2. Install the gearshift lever case boot (1) to the gearshift lever case (4); secure with a clamp.
3. Install the following items onto the gearshift control lever with the four bolts:
^ The gearshift control lever lower boot (2).
^ The boot plate (3).
^ The console box bracket (6).
^ Tighten the gearshift control lever lower boot plate (2) bolts to 7 Nm (62 inch lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.





4. Install the gearshift control lever upper boot (1) onto the gearshift control lever.
5. Install the gearshift control knob onto the gearshift control lever by screwing clockwise.





6. Install the front console box (2) to the floor. Secure the front console box with the two plastic retainers and the two screws.
7. Install the rear console box (2) to the floor. Secure the rear console box with the two plastic retainers and the two screws.