Parking Pawl and Manual Shaft Linkage Installation

1. Install new manual shaft oil seals to both sides of the transmission case using a socket and a hammer.
2. Lubricate the new oil seals with A/T fluid.
3. Install the manual shift shaft (2) and shift lever (1) to the transmission case.





4. Install the manual shift lever pin (1) to the manual shift lever hub using a hammer.





5. Slide the manual lever hub protection sleeve over the manual detent lever hub using a hammer and a chisel.





6. Install the parking pawl rod (1) to the manual shift shaft.





7. Install the following parking pawl components to the transmission case:
^ The pawl (1)
^ The pivot pin (2)
^ The torsion spring (3)
^ The plate
^ The plate bolts
- Tighten the bolts to 7 Nm (62 inch lbs.).