Operation CHARM: Car repair manuals for everyone.

TV Cable Replacement

REMOVAL PROCEDURE





1. Loosen the TV cable locknut (3) and the adjusting nut.
2. Remove the TV cable (2) from the throttle body linkage.
3. Remove the TV cable casing from the TV cable bracket at the throttle body.





4. Disconnect the negative battery cable (4).

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

5. Raise the vehicle. Support the vehicle.





6. Remove one bolt and the TV cable retaining bracket (1) from the transmission.
7. Remove the TV cable casing (2) from the transmission. Remove the TV cable end from the throttle valve.





8. Place an index mark (reference mark) (1) on the propeller shaft pinion flange and on the front differential pinion flange of the transfer case to the front differential propeller shaft.

IMPORTANT: Perform the next two steps for four-wheel drive vehicles equipped with the 03-72LE, 4-speed automatic transmission.

9. Remove the four bolts and the four nuts from the pinion flange yoke (2).
10. Separate the pinion flange yoke (2) from the front differential pinion flange (3).

11. Position and support the transfer case to the front differential propeller shaft away from the transmission fluid pan.

IMPORTANT: Removing the propeller shaft from the transfer case will result in fluid loss.





12. Remove the transmission range switch electrical connector from the transmission range switch (1).





13. Remove the transmission fluid pan (2) and gasket from the transmission. Refer to AT Fluid/Filter Changing.





14. Remove the transmission valve body (14) from the transmission.





15. Remove the TV cable (2) from the TV cable cam (3).
16. Remove the TV cable case from the transmission.
17. Inspect the TV cable for fraying or kinks. Replace the cable as necessary.





18. Inspect the TV cable O-ring (1) for damage. Replace the O-ring if necessary.

INSTALLATION PROCEDURE





1. Attach the TV cable (2) to the transmission.
2. Attach the TV cable (2) to the TV cable cam (3).





3. Install the transmission valve body (14) in the transmission.





4. Install the transmission range switch electrical connector to the transmission range switch (1).





5. Install the transmission fluid pan (2) and gasket to the transmission. Refer to AT Fluid/Filter Changing.





6. Attach the pinion flange yoke (2) to the front differential pinion flange (3) aligning the index (reference marks) (1) on the pinion flange.

IMPORTANT: Perform the next step for four-wheel drive vehicles equipped with the 03-72LE, 4-speed automatic transmission.

7. Secure the pinion flange yoke (2) with four bolts and nuts.
^ Tighten the propeller shaft bolts and nuts to 50 Nm (37 inch lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.





8. Install the TV cable casing (2) into the TV cable bracket (1) at the throttle body.





9. Install the TV cable (1) to the throttle body linkage.





10. Connect the negative battery cable (4).





11. Adjust the TV cable (2). Refer to TV Cable Adjustment.