Selector Switch Replacement (4WD Low Switch)

REMOVAL PROCEDURE





1. Disconnect the negative (-) battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Raise the vehicle. Support the vehicle. Refer to Vehicle Lifting Points.
3. Disconnect the four-wheel drive low switch electrical connector from four-wheel drive low switch.
4. Remove the four-wheel drive low switch (4) from the transfer case by turning counterclockwise.
5. Inspect the four-wheel drive switch O-ring for cuts or other damage. Replace as necessary.

INSTALLATION PROCEDURE





1. Install the four-wheel drive low switch into the transfer case by turning clockwise.
^ Tighten the four-wheel drive low switch to 20 Nm (15 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Connect the four-wheel drive low switch electrical connector (3) to the four-wheel drive low switch (4).
3. Lower the vehicle.
4. Connect the negative (-) battery cable.