Selector Switch Replacement (4WD Switch)

REMOVAL PROCEDURE





1. Disconnect the negative (-) battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Remove two screws, two plastic retainers and the rear console box from the floor.
3. Remove two screws, two plastic retainers and the front console from the floor.
4. Remove one screw and the gearshift control lever knob (2) from the gearshift control lever.
5. Remove eight screws, the boot cover and the gearshift control lever boot (1) from the gearshift control lever.
6. Remove one clamp and the gearshift lever case boot from the gear shift lever case.





7. Remove the gearshift control lever (2) from the gearshift lever case by pushing down on the gearshift control lever pivot and turning counterclockwise 90 degrees (1/4 turn) and lifting up.





8. Disconnect the four-wheel drive switch electrical connector (1) from the four-wheel drive switch (2).
9. Remove the four-wheel drive switch from the transfer case by turning counterclockwise.
10. Inspect the four-wheel drive switch O-ring for cuts or other damage. Replace as necessary.

INSTALLATION PROCEDURE





1. Install the four-wheel drive switch into the transfer case by turning clockwise.
^ Tighten the four-wheel drive switch to 20 Nm (15 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Connect the four-wheel drive switch electrical connector (1) to the four-wheel drive switch (2).
3. Install the gearshift control lever into the gearshift lever case, pushing down on the shift control lever pivot and turning clockwise 90 degrees (1/4 turn) and releasing.
4. Install the gearshift lever case boot to the gearshift lever case. Secure the boot (3) with one clamp.





5. Install the gearshift control lever boot (1) and the boot cover onto the gearshift control lever (2). Secure the boot and the cover with eight screws.





6. Install the gearshift control lever knob (1) onto the gearshift control lever. Secure the knob with one screw.
7. Install the front console box to the floor. Secure the front console box with two plastic retainers and two screws.
8. Install the rear console box to the floor. Secure the rear console box with two plastic retainers and two screws.
9. Connect the negative (-) battery cable.