k. Front Housing Assemble

Front Housing Assembly

^ Tools Required
^ Hydraulic Press
^ J 36183 Input Shaft Press Tube with Cap
^ J 36184 Adapter Press Tube Reducer
^ J 36510 Clutch Fork Pivot Remover/Installer
^ J 36507 Detent Bushing Remove/Installer
^ J 36511 Oil Fill Plug Hex Bit (17 mm)
^ J 36798 Shift Shaft Bushing Installing Tool
^ J 36190 Driver Handle





1. Install the input shaft bearing.
^ Press in the bearing until the snap ring is seated.
^ Use tool J 36183 and tool J 36184.
^ Use a hydraulic press.





2. Install the shift shaft front housing bushings. Use J 36798 and J 36190.





3. Install the two detent plunger bushings. Use tool J 36507.





4. Install the first bushing until the second scribe mark on the tool is aligned with the housing.





5. Install the second bushing until the first scribe mark on the tool is aligned with the housing.





6. Install the transmission housing vent assembly.





7. Apply pipe sealant with Teflon(TM) GM P/N 1052080 or equivalent on the fill plug threads.





8. Install the oil fill plug. Use J 36511.
^ Tighten the fill plug to 60 Nm (44 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.





9. Apply pipe sealant with Teflon(TM) GM P/N 1052080 or equivalent to the drain plug threads.





10. Install the oil drain plug. Use tool J 36511.
^ Tighten the drain plug to 60 Nm (44 ft. lbs.).