SIR Steering Wheel Module Coil - Disassemble

DISASSEMBLY PROCEDURE





1. Remove the upper and lower shrouds. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle (Floor Shift).
2. Remove the wire harness assembly (1) from the wire restraint clip (2).
3. Disconnect the SIR coil assembly connector from the turn signal switch assembly connector.





4. Remove the retaining ring (3) from the steering shaft assembly by using snap ring pliers.
5. Remove the SIR coil assembly (2) from the steering shaft assembly.
6. Remove the wave washer (1) from the steering shaft assembly.